Appendix G.Model 8032-27 And Load Cell Wiring

Connect the load cell "common" VW– conductor to the jumper as follows:

1.Lift up on the orange tab located on the opposite side of the six black conductors.

2.Fully insert the common conductor into the 8032-27 Jumper Wire Assembly.

3.Push down on the orange tab until it snaps into place.

Refer to Appendix C to identify which conductor of the load cell carries the common VW– signal.

 

Figure 10: Model 8032-27 Jumper Wire Assembly

After attaching the common conductor from the load cell to the 8032-27, the black conductors supplied with the 8032-27 may be wired into a geokon terminal or multiplexer board where the VW– signal would normally go. Wire in one black conductor from the 8032-27 for each gauge of the load cell.